Onerock Microcement 1kg Tester tubs| 1 component | Ready to use

Ready to use microcement - 1 Component 

All tubs are 1kg each so you can check the colour and also apply the product

YIELD:

ONEROCK L - 900g per m2

ONEROCK M - 450g per m2

ONEROCK S - 350g per m2

Mineral mortar formulated based on acrylic resins, additives and selected minerals to

confer high mechanical and chemical performance with low VOC emissions.

ONEROCK is a continuous highly decorative coating for professionals:

Ready to use, flexible, resistant and waterproof. It can be applied on practically any consolidated surface.

PROPERTIES:

• Continuous coating (always respect expansion joints if any)

• Applicable on almost any type of support: concrete, cement, ceramics, plaster, plasterboard, etc.

• Excellent workability

• High adherence to the support

• Does not yellow over time or by UV

Preparation for no mesh system

All surfaces must be clean, dry, level and consolidated.

Apply PRIMER or PRIMERQUARTZ primer, wait at least 30 minutes. 

Apply 1 to 2 coats of ONEROCK L applying some pressure with the trowel.

Tool: Metal trowel

Wait 8-12 hours between coats.

Sanded with 40 grit of each layer and vacuumed from the surface.

Apply 1 or 2 coats of ONEROCK M or if wanting more of a smooth finish use ONEROCK S, applying some pressure with the trowel. Tool: Metal trowel for M, Plastic trowel for S

wait 6-8 hours

Sanded with 120 (M) or 220 (S) grit and vacuumed the surface.

Application of two coats of VARNISH W water-based aliphatic polyurethane (5:1)

NOTE:

Drying times are calculated at a temperature of 20ºC and a maximum relative humidity of 60%. Adapt times to environmental

conditions.

IMPORTANT:

Apply the layers with a minimum thickness, and always wait until they dry to proceed with the next step. Promote air flow for optimal drying.